Thursday, May 9, 2013

Apagon en Hispasat 30° W  favor usar el SATMEX 6  113° W

Blackout. on Hispasat 30° W  please use SATMEX 6 113° W

Monday, May 6, 2013

Upgrade May 6


Actualizacion Viubox Xtreme Mayo 6 Viubox Atualização Viubox_May06_upgrade_2013


http://www.sendspace.com/file/4jq0to


This firmware will upgrade your decoder to patch some bugs and update all 

internal memory. You must install with Total Flash, wait until reboot DO NOT OFF 

POWER. Please allow up to 2 minutes to restart. This is the time needed to upgrade 

everything.

The decoder will show "ON" for 50 seconds, and then after 10-15 more seconds it 

will boot correctly.

IF YOU POWER OFF DURING THIS PROCCESS YOU COULD DAMAGE THE VIUBOX

----

Este firmware actualizará tu descodificador para parchear algunos bugs y 

actualizar la memoria interna

 Debes instalarlo mediante USB con la opción "Total Flash". Una vez se reincide NO 

APAGUES O DESCONECTES TU EQUIPO. El proceso puede tardar 2 minutos 

durante el arranque. Este tiempo es necesario para actualizar todo.

El decodificador mostrará "ON" durante 50 segundos, y después de 10-15 segundos 

mas este habrá iniciado correctamente

SI APAGAS EL EQUIPO DURANTE ESTE PROCESO PODRÍAS DAÑAR TU VIUBOX


Recovery


 Recovery Guide only for the killed viubox Black Screen
Guia de Recuperacion para mas maquinas Muertas Pantalla  Negra con loop ON Strt
The killed viubox can be recovery by rs232 cable with the recovery Firmware 

through rs232 cable.  


RECOVERY Viubox Upgrade Recovery http://www.sendspace.com/file/4xgjie





The process could  show a error, if the decoder shows "-end" on the led display  then replug  the +12V  power jack, take off and plug back again  

A) Usar Cabe rs232 con el programa de recovery y el firmware recovery


then just wait it do some process internal, at this moment please don't power off or remove the
power jack any more.!  it will reboot normally


En algunos casos se puede producir un error  si esto ocurre espere a que en el display aparezca la palabra END
retire el plug de 12v power y lo vuelve a poner  

El decodificador iniciara correctamente




B) Actualizar con firmware de Mayo 6  http://www.sendspace.com/file/4jq0to